 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#1
10-13-2018, 04:53 PM
|
||||
|
||||
Screw Your Gasket
Whereas screwdown lucite holders may compress cards too much and "squeeze" the corners or damage the surface and,
whereas SGC gaskets, despite being preferred by many collectors, are associated with slippage of thinner cards behind or in front of the gasket in the SGC holder and, whereas I am not willing to risk a costlier card that I want to display using either of these techniques, I offer the following: 2-209.jpg 1-209 1.jpg Save the gaskets when you crack SGC slabs. Place an appropriate gasket in a screw down lucite holder. Carefully insert the card without a penny sleeve. Replace the top of the screw down and tighten the screws as much as you like. The gasket cannot be compressed. If the card fills the gasket as this one does, it will not slip, move or be compressed. Hope that some of you may find this useful.
__________________
RAUCOUS SPORTS CARD FORUM MEMBER AND MONSTER FATHER. GOOD FOR THE HOBBY AND THE FORUM WITH A VAULT IN AN UNDISCLOSED LOCATION FILLED WITH WORTHLESS NON-FUNGIBLES 274/1000 Monster Number Last edited by frankbmd; 10-13-2018 at 06:04 PM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some screw down holders | Peter_Spaeth | Everything Else, Football, Non-Sports etc.. B/S/T | 2 | 04-30-2017 11:15 AM |
| Screw top holders | Snapolit1 | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 17 | 01-02-2016 02:29 PM |
| Did I just screw up? | the 'stache | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 18 | 08-31-2014 08:56 PM |
| SGC gasket/liner/thingy wanted | Howe’s Hunter | T206 cards B/S/T | 1 | 08-19-2014 09:46 AM |
| WTB: Screw down toploaders | karczewski | 1950 to 1959 Baseball cards- B/S/T | 0 | 12-12-2011 06:45 PM |
Threaded Mode