Tampered Holder?

[irishdenny]

imho the card will always tell more of the story then the holder ever will...

Can we see the card...?

Grade it's suppose to be?

[Steve D]

If that's a PSA holder, where's the PSA logo that should be engraved in the lower-right corner of both the front and back halves of the holder?

Also, there should be two small, clear "squares" on each side edge, and on the bottom, and one small, clear "sqare" on the top.

If those things aren't there, and it's a PSA holder, IMHO, it's a fake.

Additionally, the outer edge, to me anyway, looks more like and SGC holder than a PSA holder. SGC however, doesn't have that "cloudy" border; that's a PSA trait.

Overall, I'm confused by what the holder's supposed to be.

Steve

[drc]

My guess is it's been tampered with, because the card is missing.

[wastewater]

I apologize, I should have clarified it is an SGC holder. I removed the image of the card as it would be fairly easy to trace on ebay and I didn't want to implicate anybody if the consensus was it was tampered with.

[dog*dirt]

Originally Posted by drc

My guess is it's been tampered with, because the card is missing.

HAHA, that is funny.

[teetwoohsix]

I don't have an opinion the slab in the OP (not enough detail) but wanted to show this card- I submited this myself, and still have it. All three of the cards I submited came back from SGC with these cracks. SGC, back then, said to send them with my next sub and they would re-slab. I just haven't sent any new cards in yet, but when I do I will send these back in. My long winded story was just to say that those cracks may not mean the card was tampered with. Hope this Criger shows what I mean (my scans aren't very good)-

[glynparson]

Having actually used the sgc slabbing machine i can tell you i have seen corners look like that right off the machine. im not a big fan on the holders as they sometimes looked cracked when sealed and sometimes pop totally clean.