Help Please:How to Crack a SGC case?

[Anthony S.]

If you run a search for the word "screwdriver" you'll find about half a dozen threads on this topic. I use the same method as Darren described. Two things:

1) Turn your head away before you snap off the top corner of the slab, so that you don't end with an SGC 70 cornea.

2) Hold the screw driver close to the tip as you pry, so that your fingers will prevent the screwdriver from getting anywhere near the card.

[quinnsryche]

bandsaw

Thanks for the help everyone.

William

[tiger8mush]

i took a small flathead screwdriver, put it in the gap between the top portion and the bottom, and twisted gently till the plastic started to give. move the screwdriver up an inch and repeat. continue till the top is separated from the bottom. took me under a minute, easy. good luck!

Rob

[B O'Brien]

12 inch chef's knife and a smile!
Start up near the tang to pry the corner, then just slip the blade into the opening, twisting as you go.
I like to save then up though, as it is not much fun cracking just one.

Congrats on another KY boy!
Bob

[Tsaiko]

...before and after

[cfc1909]

If you go to any show where SGC is set up I am sure they would crack it out for you. That way you would be sure not to damage your card.