![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
|
#1
|
||||
|
||||
![]()
I use a dremel. Actually, it's a Black and Decker "rotary tool."
I begin my cut just underneath the flip, and saw down about halfway deep into the plastic, from one end of the slab to the other. Then, I just insert a flat-head screwdriver into the gap, pry upward, and the whole top half of the flip pops right off. The whole thing takes about fifteen seconds, and no sharp instruments ever get near the card. It works with all slabs, although the Beckett slab is a little tougher to cut through because it's made from space-age polymer. WEAR EYE PROTECTION. Eventually the blade weakens and breaks (I use the disposable, round, sandpaper blades), and goes flying across the room. -Al |
#2
|
|||
|
|||
![]()
Take pair of pliers, bust off top corners of slab. Jam flathead screw driver into where flip is, watch your fingers! Rotate 90 degrees until you here a popping sound. Insert flathead further into slab, rotating to pop more. Once the case is fully breached, drag tip of flathead down each side. You'll get through two or two and a half sides and the entire thing should pop out. I've done this method on many, many dozens of cases.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
speaking of ebay handles...cer89? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 0 | 01-14-2007 05:01 PM |
Speaking of M131... | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 12-17-2006 12:42 PM |
Speaking of T206 | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 8 | 11-15-2006 04:08 PM |
Speaking of starting sets....how about 1918 Zeenuts? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 9 | 11-09-2006 09:07 PM |
Speaking of backs | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 1 | 08-13-2003 09:25 AM |