 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#3
01-05-2009, 07:32 PM
|
|||
|
|||
Re: How do you crack a card out of a PSA case?
Posted By: Jeff Schwarz
This may not be acceptable or too dangerous for some but has been very effective for me. I take a straight edge screw driver and place it in the middle on the bottom side between the two pieces of plastic. Push a little and twist, move down 1/2 inch and repeat. Then move from the middle to the other side every half inch. All the while the case is cracking open. You can then go slightly up each side, pull the plastic apart and presto! Free at last, free at last! 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Am I the first to crack an SCD case? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 17 | 02-25-2010 06:10 AM |
| How do you crack a card out of a PSA slab? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 10 | 01-05-2009 08:25 PM |
| Should I crack a graded card out? | Archive | Postwar Baseball Cards Forum (Pre-1980) | 12 | 09-09-2008 11:28 AM |
| I wonder if I can trade my 87 topps case for this t200 case | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 16 | 01-16-2008 10:46 AM |
| How do I crack a card out of my BVG Beckett holder? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 8 | 08-18-2005 04:59 PM |
Threaded Mode