 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
|
|
#1
11-12-2020, 10:48 PM
|
||||
|
||||
I've wondered more about trimming. Is it obvious with a loupe? Anyone have a photo example?
|
|
#2
11-13-2020, 08:54 AM
|
|||
|
|||
|
Authenticating with a jeweler's loupe
Quote:
Easier on some sets than others. T206s, for example, generally have a distinctive edge from the factory cut that rolls from front to back. Trimming will expose the raw fibers that are visible under a 100x loupe. If I can find that smooth edge on all four sides of a card - even though natural wear may expose fibers in sections - I’m 99% sure it’s not trimmed. Last edited by Jgrace; 11-13-2020 at 08:56 AM.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jeweler's Loupe | I Only Smoke 4 the Cards | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 10 | 03-30-2014 09:06 PM |
| $old- 10x/20x Loupe | Smanzari | Everything Else, Football, Non-Sports etc.. B/S/T | 0 | 11-02-2013 12:49 PM |
| Best Loupe? | acramos1 | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 11 | 08-16-2012 11:45 PM |
| Pre Grading with a 30X Loupe | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 3 | 02-10-2009 07:07 AM |
| A Jeweler from Southern California? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 18 | 03-06-2007 09:32 AM |
Hybrid Mode
