How do you grade edge wear on 1950's - 80's cards?

[swarmee]

Some of that edge wear is actually caused by the slabs from both companies. Would depend on the location, but I've seen the "rails" of both SGC gaskets and PSA slabs damage edges.
One reason some customers prefer the mylar sleeves that PSA will put in sometimes (and BGS always does?).

[jchcollins]

Originally Posted by swarmee

Some of that edge wear is actually caused by the slabs from both companies. Would depend on the location, but I've seen the "rails" of both SGC gaskets and PSA slabs damage edges.

One reason some customers prefer the mylar sleeves that PSA will put in sometimes (and BGS always does?).

Yeah, I know what you are talking about - but that wasn’t my question. How does edge wear affect grade at what levels of severity? I’ve seen PSA 7’s and higher with some degree of edge wear (not post-slabbing due to the rails) that must have been deemed acceptable. Just kind of unsure how I feel about that. If the card has perfect corners but a noticeable edge ding, isn’t that the same or worse than a dinged corner? It’s not always graded that way.


Sent from my iPad using Tapatalk