Potential very interesting experiment with t206 Plank

[iwantitiwinit]

Originally Posted by Rhotchkiss

i believe SGC does generally cut its inner pieces to fit the card type the case holds; I think I was told this sometime back and the purpose was presentation (better framing than standard casing), but I am sure there are folks here who know better than I.

Right they cut the gasket for card type but in this case did they cut it for this specific card? For instance look at this card, I'd say the sum of the top and bottom borders are equal to or slightly more than the REA Plank yet there is a lot of extra room at the top of the gasket.

https://www.ebay.com/itm/T206-Roger-...8AAOSw-K9ZHe8O

[Luke]

Originally Posted by iwantitiwinit

Right they cut the gasket for card type but in this case did they cut it for this specific card? For instance look at this card, I'd say the sum of the top and bottom borders are equal to or slightly more than the REA Plank yet there is a lot of extra room at the top of the gasket.

https://www.ebay.com/itm/T206-Roger-...8AAOSw-K9ZHe8O

Yes, they will often cut the gasket specifically to fit and protect the card inside. Here's a good example:

[iwantitiwinit]

Originally Posted by Luke

Yes, they will often cut the gasket specifically to fit and protect the card inside. Here's a good example:

Thanks Luke!!