 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#30
02-06-2017, 06:21 PM
|
||||
|
||||
Cases. Holders? Cases...
Thanks guys.
Well, after messing with 3 or 4 more screw downs tonight, I finally said screw it and am back to toploaders. Simplicity works best, I think. For more than just a few cards, the setup with the Pro-Mold and aligning the penny sleeve (which is too big) correctly in the case is just too much of a pain. After I stripped about 2 screws just now, I took them out and a minute later everything was tucked nice and neat into toploaders. They provide good protection, they look good, and they are cheap and very easy to work with / quick to change cards in and out of when you need to. I think I was making an easy solution difficult from the start just out of the desire to try something different.  Thanks to those of you that hung in there with me on this thread.
__________________
Postwar stars & HOF'ers. Currently working on 1956, '63 and '72 Topps complete sets. Last edited by jchcollins; 02-06-2017 at 06:26 PM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cases | mwbeatles | 1960-1979 Baseball Cards B/S/T | 0 | 08-02-2016 10:03 AM |
| Cases | mwbeatles | 1950 to 1959 Baseball cards- B/S/T | 2 | 07-29-2016 04:00 PM |
| New SGC cases? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 03-11-2007 05:33 AM |
| Tampered cases | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 15 | 11-04-2005 12:26 PM |
| display cases | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 11 | 02-09-2005 05:36 PM |
Threaded Mode