![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
|
#1
|
||||
|
||||
![]()
Not as short as the tip top Wagner.
![]()
__________________
Net 54-- the discussion board where people resent discussions. ![]() My avatar is a sketch by my son who is an art school graduate. Some of his sketches and paintings are at https://www.jamesspaethartwork.com/ |
#2
|
||||
|
||||
![]()
Mine is a Lionel Carter card. Yours? No.
__________________
http://www.flickr.com/photos/calvindog/sets |
#3
|
||||
|
||||
![]()
Ah yes, submitted by Legendary. Or was it still Mastro?
![]()
__________________
Net 54-- the discussion board where people resent discussions. ![]() My avatar is a sketch by my son who is an art school graduate. Some of his sketches and paintings are at https://www.jamesspaethartwork.com/ Last edited by Peter_Spaeth; 06-05-2014 at 08:24 PM. |
#4
|
||||
|
||||
![]()
PS the offers have been nothing short of hilarious.
__________________
http://www.flickr.com/photos/calvindog/sets Last edited by calvindog; 06-05-2014 at 08:21 PM. |
#5
|
||||
|
||||
![]()
Did you expect otherwise?
__________________
Net 54-- the discussion board where people resent discussions. ![]() My avatar is a sketch by my son who is an art school graduate. Some of his sketches and paintings are at https://www.jamesspaethartwork.com/ |
#6
|
|||
|
|||
![]()
Jay is 100% correct the large holder is train wreck....perhaps SGC should look to redesign the holders vs. the labels.
|
#7
|
|||
|
|||
![]()
David I feel your pain.
My T4 did the slab shimmy dance also I was lucky no damage. I had it it slabbed in a Mylar sheet in the holder to fix the issue. Otherwise every time I looked at the card and tilted upright Mr. Weaver would begin his migration south for the winter. ![]() I agree not the end of the world but also not an non issue either. It's a problem they have known about for sometime. I look at it this way if Branson can slap people into sub orbit I would think a grading company could figure out a decent holder for the services and fees being charged.... John |
#8
|
||||
|
||||
![]()
You would think that's the case but if people keep submitting oversized in spite of the issue there is less resolve.
__________________
Check out my aging Sell/Trade Album on my Profile page HOF Type Collector + Philly A's, E/M/W cards, M101-6, Exhibits, Postcards, 30's Premiums & HOF Photos "Assembling an unfocused collection for nearly 50 years." |
#9
|
||||
|
||||
![]()
For many of these cabinet size cards, there aren't many good options. PSA only holders up to 5x7 sizes. Therefore, if it is larger than this, you need to go w/ SGC or Beckett. The Beckett slab does not have any issues w/ float. However, the slab is a brick, and not as aesthetically pleasing as SGC, so in the end, collectors prefer SGC. In addition, for these obscure prewar cards, collectors still trust SGC's opinion the most over PSA and Beckett, so in the end SGC still gets most of the business here even with the gasket issue.
Last edited by glchen; 06-05-2014 at 11:07 PM. |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
O/T: Art restoration project gone horribly awry | BradH | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 08-26-2012 11:33 PM |
A real disappointing conversation with PAYPAL... | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 15 | 04-30-2008 08:06 PM |
It could be disappointing to buy a card which is properly graded with the correct holder | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 8 | 09-15-2006 03:20 PM |
disappointing moment | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 55 | 03-11-2005 04:10 AM |