How Do You Actually Know It's Trimmed?

[Wichita]

How could a person be sure the odd edge on the Myers card is from the factory unless they were the original owner...even if they have owned the card a long time? Couldn't it be a trim job by a previous owner?

[steve B]

Originally Posted by Wichita

How could a person be sure the odd edge on the Myers card is from the factory unless they were the original owner...even if they have owned the card a long time? Couldn't it be a trim job by a previous owner?

It has all the indicators of a factory miscut. As well as factory cut.

The edge is curved down on the front surface, and there's the corresponding ridge on the back. All the edges are toned equally, although it's in nice shape so theyaren't toned much. And under high magnification the angled marks from the cutter blade are there.
The odd cut is from some piece of debris geting under the cards on the cutter. In this case probably a part of the sacrificial strip the blade goes into. With cardstock there's usually a crease from the step towards one side, but usually only on one end, and in this case it's there on both ends.

So I'm 99.9% sure it's factory. Or if not one of the oddest trim jobs ever.

And I totally understand why no grading company would slab it unless they just didn't have it together that day. (It's also got paperloss on the front that may be factory, and a bit of paperloss on the back directly relaed to one of the crease, so the best it would manage should be a 30. )

Steve B

[tbob]

Since PSA has no clue if a card has been trimmed, and they are supposedly experts, I don't know if there is any fool proof way of telling. You just go with your gut feeling, experience at looking at many cards through the years, etc. Many pre-war Registry cards with PSA 8s and 9s appear trimmed to these old eyes.

[T206Collector]

This is hard to explain in writing, but you must look at the edges of the card while holding the card flat to your eyes. The card should look like this when you are examining it:

-----------------------------------

If you are only looking at it from the face/front or back, you are missing many of the tell-tale signs.

You cannot just measure a T206, for example. You have to look at the flat sides/edges. If you ever have the chance to compare a trimmed edge to a not trimmed edge the differences do jump right out at you.