 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#14
09-19-2014, 06:39 AM
|
|||
|
|||
I don't understand why some people see a card that is short either one or both ways and automatically assume it's trimmed.
With a little bit of experience and a good loupe, it's easy to distinguish a factory cut from a non-factory cut. A card can measure short and not be trimmed. Likewise, a card can measure just fine and still be trimmed. If you look at a card that's short and automatically assume it's trimmed, then what do you think about the cards that are actually 1/8th of an inch oversized? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| canadian experience with PSA question | g_vezina_c55 | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 13 | 03-12-2013 07:28 PM |
| First grading experience and a question | Woundedduck | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 3 | 08-08-2011 11:07 AM |
| New Ebay Experience (At Least for Me) | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 9 | 03-16-2009 06:53 PM |
| Question on recent t206 lot | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 2 | 12-30-2008 06:21 PM |
| Question about recent purchase | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 23 | 08-23-2005 06:54 AM |
Threaded Mode