Kurt's Card Care

[Fuddjcal]

Originally Posted by BioCRN

SDS forms are both very specific and very generalized depending on what part of the SDS you're dealing with.

Technically, if spilled this cleaner should be cleaned with "non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations"

...realistically you'll clean it up with a paper towel, throw it in a trash can, and it will be of extremely little danger.

You would have to work in a very "by the book" lab to follow the recommended SDS procedure for every instance of a noted occurrence.

Very good points. I would just like to add a few details.
The SDS should also have "% Ranges" of the hazardous chemicals such as 5-15%, It could or should list 'Water" or distilled water and that range. Also The non haz Proprietary ingredients may include the surfactant if they are non Haz. Most are Non-Haz but that too should show a " % range". All of them should add up to at least 100%. Still not giving up any formulas or trade secrets

If the alcohol content is 15% or greater, it would need to be classified as "UN1170 Ethanol Solutions, which is an EPA RCRA Hazardous in Section 14.
If Kurt wants to call it "Non-Haz", he has to prove it with a simple "Flashpoint" test from an accredited laboratory. It costs a whopping $50 bucks. Save on the meth and get the test is my advice.

If it flashes at 140F or lower, it's Flammable. 140F-160F it's "Combustible". Both are hazardous. It may qualify to ship DOT as a "Y" Limited Quantities to his customers.

Your almost there Kurt. Good luck. Hope OSHA wasn't too hard on you.