 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#9
01-06-2009, 10:58 PM
|
|||
|
|||
Re: How do you crack a card out of a PSA case?
Posted By: Dan Collins
I use a small flat head screwdriver and a little hammer. On the side of the PSA holder there are little notches that sometimes you can pop the seal without a hammer just by sliding the screwdriver in. When I use both the screwdriver and the hammer I put the card between my knees and then tap the screwdriver through the side of the holder just enough to start popping the seal all around it. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Am I the first to crack an SCD case? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 17 | 02-25-2010 06:10 AM |
| How do you crack a card out of a PSA slab? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 10 | 01-05-2009 08:25 PM |
| Should I crack a graded card out? | Archive | Postwar Baseball Cards Forum (Pre-1980) | 12 | 09-09-2008 11:28 AM |
| I wonder if I can trade my 87 topps case for this t200 case | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 16 | 01-16-2008 10:46 AM |
| How do I crack a card out of my BVG Beckett holder? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 8 | 08-18-2005 04:59 PM |
Threaded Mode