"Scrap" and general hobby terms, possible revision?

[steve B]

Well, I don't really expect much revision to happen, but maybe to get some ideas working, prompted by the thread about a Yellow/Brown T206.

They're the most common, so most will directly apply to 206s, but could be applied to every set.

The use of the term Scrap for a yellow/brown got me thinking about how we use that term. As I said there it's a good catchall term for cards that aren't exactly normal and probably weren't pack issued because of that.

Most break down into a couple different "paths" my term for how the item would have passed through production to either release, the scrap barrel, or internal use.

The first "path" is cards that were complete or nearly complete and for some reason just didn't get finished. That can be anywhere from Simply not cut- perhaps because the sheet had problems far away from it, to cards that maybe just didn't get finished at all, but were intended to be finished. These would include, stuff like this Ewing, which is finished except for the cutting.


Or blank backs, or maybe the factory 30 no prints without the overprint on the reverse.
Most of that is probably just decent quality sheets that were leftover when the printer filled an order and moved on to whatever came next.

The second "path" would be cards that were not really finished because of obvious problems like being very out of register (despite how lax the allowable registration seems to have been. ) sheets used to adjust the presses in some way. Most of the spectacular ones are cards from sheets used as make ready sheets for multiple jobs, or with the back reversed from normal.
I would also put the Brown Old Mills and maybe the brown Lenox in this category. More the brown Old Mill, as I think the Brown Lenox are factory cut? Lenox in general is tough enough that the brown could be a group from a small order that was either first almost as smaples, or last just getting a few more to finish out the promotion.


The third "path" is to me much more interesting. Cards that were not intended for release, or simply waste cardboard used to adjust the presses.

American litho did sets of progressive proofs for a lot of what they printed for many tobacco companies. There are progressive proof books out there for a huge variety of cigar box labels. These books include a print from the master stone of each color, and various combinations of colors up to all colors. I think there may be a couple around for one of the non- sports sets but I don't recall for sure. I've never seen one for Baseball cards.
It's possible the existing proofs came from booklets of progressive proofs.

this would also include cards printed from the production plates to verify that they were laid out properly and registered properly with the other colors.
Typically in production the lightest colors are done first with darker colors coming later.
So a sheet with Yellow and Brown would be unusual. It's possible they did it to make the overall sheet more visible. Light Blue or Pink would make more sense in the overall process and provide the same function.

That makes me believe the yellow/Browns are progressive proofs from the production plates, and there would only be one or two sheets printed, most likely only one. The ones with a bit of red would probably be from sheet 2.
Why we haven't seen other combinations is a bit of a mystery, but that's perhaps explained by the fact that for instance a pink/blue progressive proof wouldn't look much like a card and wouldn't include a name. So it would be more likely to be passed over.

I believe they are proofs, and not simply "scrap"

[Ronnie73]

I added a detailed summary of the Yellow/Brown scraps on the other post. I believe that a couple sheets were taken half way through the printing process, most likely by the same person that took the full color "No Prints" sheets. Since both groups never got their scroll/overprint. A proof would still have the registration marks and some will be missing the name and team. Blank backs could have been used as a proof type of card, to get approval from the higher up's, before they went into full production.

[Ronnie73]

The following post was copied from another thread that I wrote on. Since the topic is scraps and the Yellow/Browns, I decided to copy it over to here.

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

The "Yellow/Brown" scraps are in my opinion, scraps, but they are part of a T206 subset of their own. Consisting of 29 different cards with the Sweet Caporal 350-460 Factory 30 back, which can't be found in full color, because they were never issued for release in packs, without their Overprint Scroll and the addition of the Factory 42 line added below. These 29 cards are also known as "Group A". The six Super Prints are also a part of this "Group A", and can be found with the same "Yellow/Brown" color scheme. The only difference is that the six Super Prints can be found in full color with the Sweet Caporal 350-460 Factory 30 back, because they were issued in packs with this Factory and Subject combination, unlike the other 29 cards.

Group A - Photo borrowed from Ted Zanidakis



----------------------------------------------------------------------------------------------------------------------------------------------------------------------------

The "Group B" subset consists of 28 different cards and follow the same pattern as the "Group A" backs. Where they were not issued in packs, without their Scroll Overprint and the addition of the Factory 42 line added below. The other difference between these 28 cards, and the 29+6 cards above, is they have always been found in full color, and are known as the "No Prints", even identified by PSA with the same term.

Group B - Photo borrowed from Ted Zanidakis



----------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Below is a scan of my "No Print" Group B Full Color Scrap Set. At this point in time, this is the only known complete 28 card set. A second set is possible to complete, but a few of the cards only have two known examples that exist. And those cards are locked up in different owners sets. I own a decent amount of a second set, and know where most of the other cards are, that would be needed to assemble a second set.

[steve B]

Some production cards still show the marks used to align the transfers, although most don't.
Still more show evidence of the erasure of those marks from the plate.
Those marks were at one time on every instance of every card on the plate. *
On the card posted in the original thread, On the right about halfway up is the tiny remnant of the right alignment mark in brown
At left, a thinning of the borderlne where the mark was erased a bit too much
Bottom center the remnant of the lower mark.
Top center, they either didn't have the mark or more likely got the erasure just right.


The other example has no obvious remnants of marks.

The registration between yellow and brown is the same for both examples shown making it likely they are from the same sheet.

Printing brown and yellow together even with red on occasion is not at all typical for production. Yellow would be the first color, Brown would be nearly the last, just before black.
Yellow with a darker color is typical for a progressive proof, even one pulled from the production plates.
A couple examples of progressive proofs

https://cigarlabelblog.wordpress.com...ressive-proof/

https://www.abebooks.com/servlet/Boo...hoCzykQAvD_BwE

https://www.artoftheprint.com/artist...tho_proofs.htm


The group of factory 30 cards is like you say, probably production cards that didn't get the factory change overprint.
I wouldn't call them scrap, because they are essentially finished product with no problems that would make them scrap. I believe they were leftover once the order for overprinted backs was completed.

But the Yellow/Browns from nearly every angle appear as progressive proofs from a production plate. A step that would be necessary to ensure that each plate was laid out correctly.
It's possible but unlikely that they're progressive proofs from an intermediate master. But since they represent a full width group, I would doubt that very much.
I think it's less likely that they're simply unfinished production cards.

*It's possible they used several to create an intermediate master, but I haven't seen proof of that, and it wouldn't be an easy thing to prove. There's also some evidence against that idea.

[Ronnie73]

The little bits of registration lines don't mean anything to me, because I have a bunch of cards that still have visable areas. I don't think the print runs were super strict. If the tax code matched the next batch, the extra sheets just went into those piles to be cut into single cards and inserted into packs. This was during a time when they would avoid making a lot of waste. That's why there are cards with multiple printing passes from different plates and even different jobs. There's proof of that. I believe anything that didn't print right, was put to the side to dry, and then used to line up the future jobs, until there were so many ink passes, that you couldn't tell what was what anymore. As far as the full color No Print's, and the Yellow/Browns, They both didn't get their scroll overprint. Both types were produced during the same time period. They were both hand cut from a couple sheets each. I believe it was just a father that took a couple sheets right before they were being loaded into the printer to receive their overprint, and he probably ran a couple sheets with whatever was set up at that moment and took them home to his kids. The colors chosen, don't make sense, so why do it? Unless it was just for a workers kid. They had no value and missing some colors or a tax overprint, wouldn't mean anything to a kid back in 1911. No T206's are known with single color passes, like you can find on Topps cards from the 1960's and 1970's. Actual proof examples would resemble the eight southern league cards that were never issued that are owned by Keith Olbermann. There are also production cards that have the same exact registration marks, which were mockup's, also known as proofs, but these proofs are always full color, so I don't see the need to print single color passes, unless something was not printing correctly, and they needed to see each color one at a time. If they did, where are they? In 2011 I made a list of the cards that could exist with the missing overprint scroll. I figured they could exist if someone removed a sheet or two, before the overprint was applied, and then they took the sheet or sheets home with them. It took me 3 years to find my first two examples. You can even see on some of them where someone used a pencil to draw a grid, to help cut them into singles. If they were proofs and wanted them cut into singles, they would have just used the clamp with the cutting blade. No uneven cuts. It was just a guy trying to be a good dad to his kids. 112 years later, and many of the cards still exist. I guess we will have to wait to hear some other opinions.

[G1911]

I apologize if I've missed something, but I'm not really seeing why we would assume it is a proof rather than just from a sheet that wasn't finished. I see this all the time, a card that isn't complete being labelled as a proof. I have thousands of T cards with the alignment marks by the frame borders, they were included in productions long after proofing. T cards we can say are definitely proofs are beyond rare, there are very very few of them still around.