 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
#1
06-05-2011, 09:28 AM
|
|||
|
|||
Degree of Trimming Affecting Value?
What are your thoughts on how the degree of trimming effects value - presumably a card where the border is completely removed on all 4 sides retains less value then a card with a slight trim to one edge, but what about the stages in between? I'm tracking a pricey card now in an auction that has the border completely removed on one edge - would you value that the same as if it was just trimmed slightly on that edge?
Last edited by Matt; 06-05-2011 at 09:29 AM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Trimming | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 3 | 08-12-2007 12:49 PM |
| Effect of Trimming | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 10 | 03-31-2007 03:58 AM |
| SGC Collector T206 Trimming Article | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 5 | 01-20-2007 01:09 PM |
| Trimming issue....lessons learned | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 8 | 01-02-2006 03:34 PM |
| evidence of trimming vs. cut short | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 04-08-2005 04:18 PM |
Threaded Mode