[Archive]

Posted By: Mark

Mike:
I bet it will be beautiful...

But I don't fully understand about the "Breathing" thing. I understand that in order to allow it to "breathe", they must secure it to the backing. I am personally just leary of stitching or taping the pennant on the back side.

I guess you can test their tape on a cheaper pennant first, just to be sure it does not "pull off" any of the felt when removed.

Greg:
Your Red Sox example looks like it is right up against the glass. Is this correct? I know that on a previous post, you showed a different framed pennant with a "cut out" in the Mat (around the perimeter of the pennant). That one appeared to have room to breath, probably having a slight gap between the pennant and the glass. Assuming so, how was that one secured to the backing?

I realize this sounds very OCD... but am just curious about alternatives, as I have a bunch of these framed, using only pressure (spring clips) to hold them directly against the glass.