Quote:
Originally Posted by begsu1013
"I'll be visiting him in a couple days and will be able to compare it to his other 68's just to be absolutely sure."
well i think we were all considering that he was going to do the obvious.
but if not, make sure you take breaths of air as well...
that's probably the most important step before finding a ruler!
|
It seems obvious, but the OP mentioned he compared the card to another issue of the same size, and did not mention measuring the card. I took that to mean he had not measured it. A ruler seems like a logical place to start.
But yes if it's been measured and checks out, or even if it didn't, I would resubmit to PSA, and even try SGC and then BVG.
The minsize note from PSA would seem to indicate that there were no signs of trimming but the card did not measure correctly. I believe this is attributed to it being miscut at the factory.
__________________
Successful transactions with peter spaeth, don's cards, vwtdi, wolf441, 111gecko, Clydewally, Jim, SPMIDD, MattyC, jmb, botn, E107collector, begsu1013, and a few others.
|