Quote:
Originally Posted by buymycards
We have been seeing this a lot lately. The package gets accepted at a Post Office and it gets scanned at a processing plant near the Post Office, then it disappears off of the radar for a week, or 10 days, or 2 weeks. Then all of a sudden it shows up as "arrived" at the delivery Post Office and it gets delivered. It seems like for the past couple of months this has been happening more frequently. I wish I could figure out why is happening, but if you are patient, 99.999% of the packages will be delivered.
As far as an item not getting tracked at all, there are some problems caused by the mailers that contribute to this and I am seeing many, many of these.
First, replace the ink cartridge on your printer. The tracking hardware can't scan a bar code that is faded or that has some bars missing. You wouldn't believe how many of these I see every day.
Second, don't shrink the size of the label that is generated from eBay so you can save some paper and ink. We can't scan a bar code that is compressed and only an inch long.
Third, make sure the entire bar code is flat. We see a lot of labels that aren't applied correctly and the labels are wrinkled, which results in a couple of the bars in the bar code that are missing. We need to be able to scan all of the bars in the bar code.
Fourth, make sure that the bar code is on the address side of the package. These packages all go through machines and the machine will read the package label, but if the bar code is on the back of the package it won't get read.
Fifth, don't use glossy or colored paper for your labels. The glossy paper reflects the beam from the scanner and sometimes the scan is missed. Colored paper also causes problems, especially red paper. Don't tape over the bar code because of the reflection from the tape. Make sure you are printing the bar code with black ink.
I hope this saves you from some problems down the road. Remember that until the final delivery, all of the scans and processing are performed by machines and computers with very little human contact, so you need to make sure that everything is legible and machine readable.
Rick
|
All good advice.
When I was selling, and with the occasional label I print now I print onto plain paper. So I have to tape it. I just tape around the bar code so it's just paper where the code is.
This point
"
Third, make sure the entire bar code is flat. We see a lot of labels that aren't applied correctly and the labels are wrinkled, which results in a couple of the bars in the bar code that are missing. We need to be able to scan all of the bars in the bar code. "
Would be a whole lot easier is they didn't require a non-priority mail piece to be 3/4 of an inch thick for delivery confirmation. Putting a packing peanut in the envelope makes it ok, but bulged so there's no way it will be flat.
I had one package rejected as being too thin, and when I was talking to the guy at the main PO it was pretty funny. I went home and printed out the section where it said stuff that wouldn't bend or that was 1/4 inch thick was a package as far as rates were concerned. And he had the printout that said 3/4" was the minimum for DC. What was funnier was that whoever wrote it up made it postage due, but returned it to me for more postage. But instead of writing it up for the balance between what I'd paid and priority they wrote it up for additional weight under rates that hadn't been current for around six months.
I even called the customer service in RI and asked about the 3/4 inch thing. They agreed that a flat object was much easier to handle than a puffy envelope, even for the machine. But also said that getting a rule changed could take years.
Steve B