Touchy-feely
 

Posted By: <b>Bill Todd</b><p>I just got a card in today's mail, my first N-300. It's in an SGC slab, and it looks great--no creases, no paper loss, bright image. I have to admit, though, I have this really strong urge to bust it out just so I can actually hold it.<br /><br />Any suggestions for popping open a slab so that you can put it back together? (Though it's an "AUT" slab, so I wouldn't be giving up much by leaving it out.)<br /><br />Bill

Touchy-feely
 

Posted By: <b>Steve</b><p>Such boredom now that the Olympics have ended. (:

Touchy-feely
 

Posted By: <b>Shawn Chambers</b><p>Hey Bill,<br /><br />No suggestions, but I, too, hope to be as thrilled when I can finally land my first N300. I've been wanting one for quite some time and will probably end up with an "A" myself. Good luck to you.<br /><br />Shawn

Touchy-feely
 

Posted By: <b>barrysloate</b><p>Bill- it's not hard to free the card from the slab, but like Humpty Dumpty, you can't put it back together again.

Touchy-feely
 

Posted By: <b>Anthony S.</b><p>If it's an AUT, bust it out. You can always have it re-slabbed if you cross back over to the dark side.

Touchy-feely
 

Posted By: <b>Anthony N.</b><p>put a knife blade into each corner seam and twist. Once you've done this go up the sides doing the same.<br />SGC's holders are really easy to pop out, I've done a few with my fingernail. <br />No downside of popping an A holder. Best of luck and congrats on the card.<br /><br />