Factory cut ?
 

Posted By: <b>Anonymous</b><p>Is this miscut or a bad trim job ? At the top it looks like there is a tiny bit of a name from another card on the sheet. But not enough to know for sure.<br /><br />I think it is untrimmed due to the bottom also being off,but would like some other thoughts as well.<br />How would this effect a third party grade ?<br /><br /><br /><br /><img src="http://www.network54.com/Realm/tmp/1130869717.JPG">

Factory cut ?
 

Posted By: <b>Josh K.</b><p>Im going with factory cut.

Factory cut ?
 

Posted By: <b>Keith O'Leary</b><p><P>I agree, factory cut.</P><P>&nbsp;</P><P>Keith</P><P>&nbsp;</P>

Factory cut ?
 

Posted By: <b>tbob</b><p>Factory cut but you have to be careful who it gets submitted to if you want to grade it. PSA will grade it and add an MC qualifier but SGC and GAI might reject it altogether. Just depends...

Factory cut ?
 

Posted By: <b>scott ingold</b><p>Why would they reject it ? I mean if it's a factory cut than on what basis could it be rejected ? I refuse to use PSA and send most to GAI.

Factory cut ?
 

Posted By: <b>Josh K.</b><p>Ive sent plenty of miscuts to sgc and they have all graded. I believe (someone can correct me if Im wrong) that SGC will only reject a miscut if it won't fit into a gasket/insert.

Factory cut ?
 

Posted By: <b>tbob</b><p>Josh- that surprises me but I do not doubt your word. I am encouraged that SGC wil do that and will resubmit a couple of cards that were once rejected as miscut and see if I have the same luck.<br />Bob

Factory cut ?
 

Posted By: <b>Josh K.</b><p>Bob,<br /><br />I may just be a question of degree. For example, here is one of my cards that crossed to SGC with no problem. The miscut is obvious, the the size is still fairly standard.<br /><br /><img src="http://www.network54.com/Realm/tmp/1130873860.JPG">