Need Advice Submitting to PSA???
 

I have a couple of 1916-20 UNC big heads that are (RAW)
and a couple that are SGC graded.
How do i go about sending these into PSA????
1. Do they need to be into 2 separate submissions?
2. Can i put the (raw) into penny sleeves before into a CardSaver 1 holder?
Would like some answers please??

1) Yes, they would be two different submission types because one is for Grading and one is for Crossover. If you want to crack out the SGC ones and send raw, then it would be 1 submission. You can mail them in the same package to PSA, but you'll need both sets of order forms and pay return shipping for each sub.
2) Yes.

Thanks for the reply.
Its been a long time for me and i never done this type of sub before.
Plus, I never cracked a holder before, scares the sheez to do it.

Just grab some aviation snips and have at it. Very easy. You didn't ask for it, but here's a short tutorial I made about it, if you want to take a look:
https://youtu.be/ynvzyfNcIVM

SGC holders have historically been the easiest. I have cracked most of them (pre-tuxedo years) just by running a butter knife up and down the space on the edge. It will pop out after a while with two separated halves, not even cracked.

I think it will give PSA a better shot to evaluate the card, because if you're giving a minimum requirement and they can't see the edges of the card due to the gasket, they may just fail it since they can't even look for trimming on the whole edge.

Thanks guys.
These are my UNC Big Head hand-cut cards, so most likely Auth.
Been trying to complete my PSA registry set..still need 2 cards to finish it.