View Full Version : Frosty edges
Archive
03-06-2008, 02:01 PM
Posted By: <b>Paul Carek</b><p>Does anyone have a good scan of what the "frosty edges" on a tampered-with PSA slab look like? I've read a lot about the phenomenon, but have yet to see a good image of what to look out for. <br /><br />A grateful sort-of-newbie thanks you for your help.
Archive
03-06-2008, 02:06 PM
Posted By: <b>PC-T206</b><p>Recently discussed here -- with an example:<br /><a href="http://www.network54.com/Forum/153652/message/1203907449/Does+this+PSA+holder+look+tampered+with" target="_new" rel="nofollow">http://www.network54.com/Forum/153652/message/1203907449/Does+this+PSA+holder+look+tampered+with</a>-
Archive
03-06-2008, 02:10 PM
Posted By: <b>Paul Carek</b><p>Exactly what I was looking for. Thanks very much for posting.
Archive
03-06-2008, 05:14 PM
Posted By: <b>Scott Levy</b><p>I've cracked PSA cases before for resubmission and sometimes the frosting is pretty minor....BUT there is almost always an entry point that gets frosted and untampered with PSA slabs almost never have this<br /><br />Regards,<br />Scott
Archive
03-06-2008, 05:21 PM
Posted By: <b>Brian</b><p>Here is the same link, but shows the entire thread instead of a single message within the thread...<br /><br /><a href="http://www.network54.com/Forum/153652/thread/1203907449/Does+this+PSA+holder+look+tampered+with" target="_new" rel="nofollow">http://www.network54.com/Forum/153652/thread/1203907449/Does+this+PSA+holder+look+tampered+with</a>
Archive
03-06-2008, 05:21 PM
Posted By: <b>leon</b><p>Good points.....